The inner layer for this hose is made of fluoroelastomers and PTFE particles, which makes it have good resistance to both acidic and some basic CIP cleaning solutions.
It is recommended especially when a smaller bending radius is required. These hoses are able to transport liquid or semi-liquid foodstuffs at high temperatures by impulsion or suction since their design can resist pressure or vacuum.
Shapes such as elbows and curvatures can also be manufactured to adapt them to any installation.
Properties
- Completely non-toxic.
- White and smooth inner and outer appearance.
- Can be equipped with 316L stainless steel fittings on each end with a roughness value of less than 0.8 (or 0.5 on request).
- Operational temperature ranges from -20ºC (-4ºF) to +175ºC (347ºF), it may reach up to +200ºC (372ºF) during short periods of time.
- The standard manufacturing length is 4 meters long (13.12 ft.), but in specific diameters, a length of 6 meters (19.69 ft) can be manufactured.
- The vacuum resistance hose is 0.91bar (13.23psi).
- It can be cleaned with steam or SIP process at 130ºC and CIP process – acidic and some basic under demanding conditions.
Limitations
Respect the bending radius and work pressure established values.
This product is not recommended for the transport of abrasive particles.
Regulations
The inner layer of Flexip is produced in compliance with:
- US FDA Standard 21 CFR 177.2600.
- USP Class VI <88> in vivo test, 121ºC.
- ResAp 2004 (5), according to Reg 1935/2004/EEC, and Reg10/2011/EEC with simulants A (10% of ethanol) and simulant D2 (olive oil).
Platinum cured silicone produced in compliance with:
- US FDA Standard 21 CFR 177.2600.
- German BfR Standard part XV.
- USP Class VI <88> in vivo test, 121ºC.
- ISO 10993-4, 5, 6&10.
- ResAp 2004 (5), according to Reg 1935/2004/EEC, and Reg 10/2011/ECC.
- Eurepan Pharmacopeia 3.1.9
- 3A Sanitary Standard 18-03 Class I (material).
This hose is in accordance with EU Directive 2002/95/ECC for Restriction of the use of hazardous substances (RoHS)
Technical Specifications:
Construction
This reference is manufactured with a hybrid inner layer between fluoroelastomers and PTFE, with three polyester fabric reinforcements and a stainless-steel wire spring, everything encased inside the hose.
Use precautions
- Extreme working conditions or the use of materials with low compatibility with Flexip can attack the inner surface of the hose. It is advisable to inspect the inner appearance for cracks or swelling, and replacement of the hose, if necessary.
- Hose cover: Should be inspected over the entire length for signs of hardening, abrasion, cuts, kinking or crushing.
